 |
HEA002 |
profi heater 2kw, recommended for 2220 gallons, easy installation.
“Profi – Heater” will appeal to all pondkeeper’s who prefer to retain the activity of fish during the winter months by increasing the water temperature. The unit incorporates a stainless steel inner lining to the SS electric heating element, with a sturdy remote thermostatic controller box providing a maximum temperature up to 40C (achieved subject to water volume, temperature & insulation).
SAFETY General User Tips For Pumps & Heaters: 1: As with all pond related electrical products pumps, heater units, UV's, etc, should for safety purposes be connected via a RCD unit.
2: To achieve maximum flow rates make use of the largest diameter hose (or rigid pipe), and keep bends or long horizontal runs restricted to a minimum.
3: Where applicable correct use of the float switch will ensure that in the event of a pipe or filter failure that the pond is not emptied of water to the point of killing the fish. For this reason do make sure that the float switch balloon always has free movement to travel.
4: In the rare event of poor performance or pump failure check the device for internal blockage. Always disconnect from the electric's supply before doing this. On the "Power Pump" range the base plate should be removed for inspection of the impeller, however it must NOT be dismantled beyond this point.
5: Temporary blocking on a pump will likely activate the thermal cutout switch. This is a good safety feature, and is not an indicator of a manufacturing fault. In any event of failure allow 20 minutes for the pump to cool down and the auto switch to restart - before taking any further remedial action.
|
